Housing feet rubber inserts for Grundig TS1000 chrome feet 2pcs.

Custom-fit rubber inserts for the chrome feet of the Grundig TS1000
The rubber inserts are made to measure and are glued into the chrome base with double-sided adhesive tape.
Comparable and perfectly fitting replacement to the original from Grundig from 1976.
Safe stand and protection against slipping for the TS1000.
Material: 65° shore A, black
1x set of 2 housing feet rubber inserts for Grundig TS1000 chrome feet (delivery WITHOUT chrome feet or Grundig panel)

€8.95*

Content: 2 Piece (€4.48* / 1 Piece)

Ships tomorrow if order is paid by 2:00 p.m
worldwide shipping from €7.45
Budget Shipping just 2,95 € (domestic Germany)
One month right of withdrawal

SKU: 10033

The Grundig TS 1000 has two chrome feet mounted on the bottom of the housing. Their rubber inserts dissolve almost completely after 44 years. These replacement rubber inserts are made to measure and are glued into the chrome base with strong, double-sided adhesive tape.
The rubber corresponds to the original Grundig quality from 1976.
Assembly note:

Lay the TS1000 on its back. If you have mounted the plastic feet, please unscrew them.
Remove the rubber residue in the chrome base, if necessary with a little cleaning spirit. Allow to dry well, the adhesive surface must be dust-free and clean.
Peel off the protective film on the rubber insert and place the rubber insert in the slot of the chrome base. Repeat this with the second foot.
Set up your TS1000 vertically and leave it like that for 24 hours.

The rubber inserts prevent the machine from slipping, so if you want to change its position, you should lift the machine and not pull on the rubber insert. If the rubber insert comes loose, you can also glue the special rubber in place with hot glue.