Refurbishment kit: housing feet, screws and rubber strips for Grundig TS1000 (set of 12)

The screw set for the Grundig TS1000 includes 6 rear panel screws including 4 rubber feet for the rear panel. The screws have a TORX head and are made of stainless steel.
The 4 rubber feet are round and made in such a way that the rear panel tension can be restored. The TS1000 is now again stable and aligned.
The Grundig TS 1000 has two chrome feet mounted on the bottom of the housing. Their rubber inserts dissolve almost completely after 44 years. These replacement rubber inserts are made to measure and are glued into the chrome base with strong, double-sided adhesive tape.
The rubber corresponds to the original Grundig quality from 1976.
Consists:
4x rear panel screws TORX DIN 14579 A2 M4x25mm;
4x rubber device feet with 4mm bore;
2x rubber inserts for chrome feet.
Assembly instructions for rubber inserts for chrome feet:

1. Lay the TS1000 on its back. If you have mounted the plastic feet, please unscrew them.
2. Remove the rubber residues in the chrome base, if necessary with a little cleaning spirit. Allow to dry well, the adhesive surface must be dust-free and clean.
3. Peel off the protective film on the rubber insert and place the rubber insert in the slot of the chrome base. Repeat this with the second foot.
4. Set up your TS1000 vertically and leave it like that for 24 hours.

The rubber inserts prevent the machine from slipping, so if you want to change its position, you should lift the machine and not pull on the rubber insert. If the rubber insert comes loose, you can also glue the special rubber in place with hot glue.